Download Drivers

Hello,

I'm having trouble finding the driver for my CH340G device on Windows 10. I've searched on the manufacturer's website, but I couldn't find a direct link to the driver. I've also searched on various driver download websites, but most of them seem to redirect to potentially shady third-party sources. I really don't want to compromise the security of my computer by downloading from unreliable sources. Could someone please provide me with a trusted and direct download link for the CH340G driver specifically for Windows 10?

Thanks in advance for your help!

Below you can download ch340g windows 10 driver for Windows.

File name: ch340g-win10.exe
Version: 8.712
File size: 20.20 MB
Upload source: original install disk
Antivirus software passed: Norton ver. 5.90

Ch340G Driver Windows 10

(click above to download)


Device Specification:

- Device: CH340G USB to UART TTL Converter Module
- Compatibility: Windows 10
- Driver: CH340G Driver for Windows 10
- Function: Enables communication between USB and UART interfaces
- Chipset: CH340G
- Voltage: 3.3V or 5V selectable
- Baud Rate: 50bps to 2Mbps
- Ports: USB Type-A and 6-pin header
- Interface: UART (Universal Asynchronous Receiver-Transmitter)
- Dimensions: 20mm x 34mm

Troubleshooting Questions and Answers:

1. Q: Why is my CH340G device not being recognized by Windows 10?
A: Ensure that you have installed the correct CH340G Driver for Windows 10. You can download the driver from the manufacturer's website and follow the installation instructions carefully. Also, check if the device is properly connected to the computer and try using a different USB port.

2. Q: Can I use the CH340G device with a voltage other than 3.3V or 5V?
A: No, the CH340G USB to UART converter supports only 3.3V or 5V selectable voltage modes. Using any other voltage may result in damage to the device and connected components.

3. Q: Why am I experiencing issues with data communication through the CH340G device?
A: Check the baud rate settings on both the CH340G device and the connected device (e.g., microcontroller). Ensure that both devices are set to the same baud rate for proper communication. Additionally, verify the integrity of the USB cable used, and if possible, try using a different cable to rule out any cable-related issues.

Thank you so much for sharing the link to the working Windows driver for the CH340G device, I have been searching for this for quite some time!