Below you can download uno r3 driver for Windows.
File name: uno-r3.exe
Version: 6.641
File size: 19.17 MB
Upload source: original install disk
Antivirus software passed: Symantec version 1.47
Uno R3 Drivers(click above to download)
Specifications:
- Size: 68.6 mm x 53.4 mm
- Microcontroller: ATmega328P
- Operating Voltage: 5V
- Digital I/O Pins: 14 (of which 6 provide PWM output)
- Analog Input Pins: 6
- DC Current per I/O Pin: 20 mA
- Flash Memory: 32 KB (ATmega328P) of which 0.5 KB used by bootloader
- SRAM: 2 KB (ATmega328P)
- EEPROM: 1 KB (ATmega328P)
- Clock Speed: 16 MHz
Troubleshooting Questions and Answers:
1. Problem: The Uno R3 is not powering up or showing any signs of life. What could be the issue?
Answer: In such cases, double-check the power connections. Ensure that the Uno R3 is properly connected to a 5V power source and the power supply is providing the required voltage. Also, make sure the power jack or USB cable is correctly plugged in.
2. Problem: I am unable to upload my program to the Uno R3. Why is this happening?
Answer: Troubleshoot the connection between the Uno R3 and the computer. Ensure that the correct Uno R3 board and port are selected in the Arduino IDE. Check if the USB cable is properly connected to both the Uno R3 and the computer. Restarting the computer and trying a different USB port may also resolve the issue.
3. Problem: The Uno R3 is not responding to my inputs or giving incorrect outputs. What should be done?
Answer: Verify the code and wiring connections. Ensure that the inputs are correctly wired, and the code corresponds to the desired functionality. Double-check the pin configurations and data types used in the program. If using external components, confirm they are connected properly and functioning as intended.