Download Drivers

Hello everyone,
I recently purchased a JBL Clip 3 Bluetooth speaker and I'm having trouble finding the driver for Windows 10. I've searched extensively on the official JBL website, as well as various other driver websites and forums, but I haven't been able to locate the specific driver I need. Could someone please provide me with a direct download link for the JBL Clip 3 driver compatible with Windows 10? I would greatly appreciate any assistance you can offer. Thank you so much in advance!

Below you can download jbl clip 3 windows 10 driver for Windows.

File name: jbl-clip3_win10.exe
Version: 8.704
File size: 41913 MB
Upload source: other website
Antivirus software passed: Norton v 4.23

Jbl Clip 3 Driver Windows 10

(click above to download)


Specifications of the JBL Clip 3 device:

1. Speaker Type: Portable Bluetooth speaker
2. Dimensions: 5.4 x 3.8 x 1.8 inches
3. Weight: 0.49 pounds
4. Bluetooth Version: 4.1
5. Battery Capacity: 1000mAh
6. Battery Life: Up to 10 hours
7. Waterproof Rating: IPX7 (can be submerged in up to 1 meter of water for 30 minutes)
8. Output Power: 3.3W RMS
9. Frequency Response: 120Hz – 20kHz
10. Signal to Noise Ratio: > 80dB

Troubleshooting Questions and Answers:

Q1: Why is my JBL Clip 3 not connecting to Windows 10?
A1: There could be several reasons for this issue. First, ensure that the speaker is turned on and in pairing mode. Then, check if your Windows 10 device has its Bluetooth turned on and discoverable. If the problem persists, try restarting both your speaker and Windows 10 device. You may also need to remove any existing Bluetooth connections from your device and attempt to pair again.

Q2: Can I use the JBL Clip 3 while it's charging?
A2: Yes, you can use the JBL Clip 3 while it's connected to a power source and charging. It will continue to function normally and charge simultaneously. However, keep in mind that the charging time may be slightly longer if you are using the speaker while it's charging.

Q3: How can I reset my JBL Clip 3 to factory settings?
A3: To reset the JBL Clip 3 to its factory settings, press and hold the Volume Up and Play/Pause buttons simultaneously for around 3 seconds. The speaker will then power off. Once turned on again, it will be restored to its original factory settings.

Thank you so much for sharing this link to the working Windows driver for the JBL Clip 3, I really appreciate it!