Download Drivers

Hi everyone,

I've been looking for the Morpho driver download specifically for Windows 7, but I haven't had any luck so far. I've already spent some time searching on the official Morpho website, as well as popular driver download sites like Driver Easy and Driver Guide, but unfortunately, I couldn't find the driver for my operating system.

I would really appreciate it if someone could provide me with a direct link or source where I can download the Morpho driver for Windows 7. I understand that drivers can sometimes be difficult to find, but I'm hopeful that someone here might have a solution. Thank you in advance for any help or guidance you can offer!

Below you can download morpho for windows 7 driver for Windows.

File name: morpho-for_win7.exe
Version: 1.182
File size: 27364 MB
Upload source: manufactuter website
Antivirus software passed: McAfee v. 2.99

Morpho Driver Download For Windows 7

(click above to download)


Device: Morpho USB Biometric Device

Specifications:
- Supported OS: Windows 7 and above
- USB interface: USB 2.0 or higher
- Biometric technology: Capacitive fingerprint sensor
- Resolution: 500 dpi
- Authentication methods: Fingerprint recognition
- Sensor dimensions: 14 x 16 mm
- Image capture time: <1 second
- Certification: STQC, FBI PIV
- Power supply: USB bus-powered

Troubleshooting Questions and Answers:

Q1: The Morpho USB biometric device is not being detected by my Windows 7 computer. What should I do?
A1: Ensure that the device is properly connected to the USB port. Try using a different USB port or cable. Install the latest Morpho driver for Windows 7 from a trusted source and restart the computer. If the issue persists, contact technical support for further assistance.

Q2: I am unable to enroll fingerprints on the Morpho USB biometric device. What could be the problem?
A2: Make sure that you are placing your finger correctly on the sensor and following the instructions for finger placement during enrollment. Check if the sensor surface is clean and free from any dirt or residue. Try enrolling a different finger to see if the issue is specific to a particular finger. If the problem continues, update the Morpho driver to the latest version and try again.

Q3: After successful fingerprint enrollment, the device is not recognizing my fingerprint for authentication purposes. How can I resolve this issue?
A3: Ensure that you are placing your registered finger correctly and applying the correct amount of pressure on the sensor while authenticating. Make sure that your finger is clean and dry before attempting authentication. If your fingers are too dry, you can lightly moisturize them before using the device. Try cleaning the sensor surface with a soft cloth to remove any smudges or residue. If the problem persists, re-enroll your fingerprint or contact technical support for further assistance.

Thank you so much for sharing the link to the Windows 7 driver for the Morpho device, I really appreciate it and will give it a try right away!