Download Driver Usb To Serial Uc232A

[Susie89]

I recently purchased a USB to Serial converter, specifically the UC232A model. However, I am unable to find the driver for it anywhere. I have searched on the manufacturer's website, as well as on various driver download websites, but I have had no luck. Could someone please provide me with a direct link to download the driver for the UC232A USB to Serial converter? I would greatly appreciate any help.

[Detective]

Below you can download usb to serial uc232a driver for Windows.

File name: usb-to-serial-uc232a.exe
Version: 5.973
File size: 25051 MB
Upload source: manufactuter website
Antivirus software passed: AVG ver. 2.6

Download Driver Usb To Serial Uc232A

(click above to download)


Specification of the device:
- Name: USB to Serial UC232A
- Type: Converter cable
- Interface: USB to RS-232
- Compatibility: Windows, Mac, and Linux operating systems
- Supported baud rates: 300 bps to 921600 bps
- Connector: USB Type-A male to DB9 male
- Cable length: 1.5 meters
- LED indicators: Power, TX, RX
- Power source: USB bus-powered

Troubleshooting questions and answers:

1. Question: Why is the USB to Serial UC232A not being recognized by my computer?
Answer: Ensure that the UC232A driver is properly installed and up-to-date for your operating system. Connect the cable firmly to both the USB and serial ports. Try using a different USB port and verify that other USB devices are working properly.

2. Question: Why is the data transfer speed too slow when using the UC232A cable?
Answer: Confirm if the baud rate settings on both the transmitting and receiving devices are matching. Ensure that the cable length does not exceed the maximum supported length. Check if any other software or firmware is affecting the transfer speed. Try utilizing a different USB port on your computer.

3. Question: Why are the TX/RX LED indicators not illuminating on the UC232A cable?
Answer: Check if the UC232A cable is properly connected on both ends. Verify that the data transmission is occurring by analyzing the device receiving the data, as the indicators might not work due to certain configurations. In case the indicators remain unlit, consider reinstalling the drivers or testing the cable on a different computer to isolate potential hardware issues.

[Susie89]

Thank you so much for providing the link to the working Windows driver for the USB to Serial UC232A device, it worked perfectly for me!